Technical Data
The rubber seal of the cover contacts with the shaft by its two lips, as shown in Fig. 2.2 and 2.3. By filling the groove between the two lips with grease, an excellent sealing effect is obtained and, at the same time, the contacting portions of the lips are lubricated. Furthermore, the groove is so designed that when the shaft is inclined the rubber seal can move in the radial direction.
When bearing units are exposed to splashes of water rather than to dust, a drain hole (5 to 8 mm, 0.2 to 0.3 inches in diameter) is provided at the bottom of the cover, and grease should be applied to the side of the bearing itself instead of into the cover.
2.4 Secure fittingFastening the bearing to the shaft is effected by tightening the ball-end set screw, situated on the inner ring. This is a unique bearing feature which prevents loosening, even if the bearing is subjected to intense vibrations and shocks.
2.5 Self-aligningWith the bearing unit, the outer surface of the ball bearing and the inner surface of the housing are spherical, thus this bearing unit has self-aligning characteristic. Any misalignment of axis that may arise from poor workmanship on the shaft or errors in fitting will be properly adjusted.
Fig. 2.3 Cast iron cover
Fig. 2.2 Pressed steel cover
2.6 Higher rated load capacityThe bearing used in the unit is of the same internal construction as those in bearing series 62 and 63, and is capable of accommodating axial load as well as radial load, or composite load. The rated load capacity of this bearing is considerably higher than that of the corresponding self-aligning ball bearings used for standard Plummer blocks.
2.7 Light weight yet strong housing
Housings for bearing units come in various shapes. They consist of either high-grade cast iron, one-piece casting, or of precision finished pressed steel, the latter being lighter in weight. In either case, they are practically designed to combine lightness with maximum strength.
2.8 Easy mountingThe bearing unit is an integrated unit consisting of a bearing and housing. As the bearing is prelubricated at manufacture with the correct amount of high-grade lithium base, it can be mounted on the shaft just as it is. It is sufficient to carry out a short test run after mounting.
2.9 Accurate fitting of the housingIn order to simplify the fitting of the pillow block and flange type bearing units, the housings are provided with a seat for a dowel pin, which may be utilized as needed.
2.10 Bearing replaceabilityThe bearing used in the bearing unit is replaceable. In the event of bearing failure, a new bearing can be fitted to the existing housing.